0item(s)

You have no items in your shopping cart.

Product was successfully added to your shopping cart.
  • CZ Fiber Optic Front Sight 1.5 x 5.5mm (3.1mm Blade)

CZ Fiber Optic Front Sight 1.5 x 5.5mm (3.1mm Blade) CZ 75

Quick Overview

Fiber Optic Front sight for CZ Pistols 1.5mm Diode x 5.5mm High x 3.1mm Blade Width.


CZ 75 Pistols come as standard with a  5.5mm Front sight


Please Visit the FAQ for Installation Photos.


Fitting Front Sight
Remove the roll pin using the appropriate punch http://czcustom.com/czpunch.aspx
Tap the old front sight out (towards the muzzle) using an appropriate soft hammer or soft block

Replace the new front sight into the dovetail and tap it toward the back of the gun until it seats in the rear of the dovetail cut. Make sure it goes all the way back.

Using the correct drill, http://czcustom.com/CZ_Front_Sight_Drill.aspx
Drill through the roll pin hole (IMPORTANT) Drill from the left side of the gun to the right side, Drill cut clockwise and drilling from this direction will not cause the front sight to walk out as the drill starts to cut.

Replace the front sight pin, new pins are available http://czcustom.com/czfrontsightpin.aspx

sku: 10085
$35.00

Availability: In stock

Details

1.5mm Fiber x 5.5mm High (3.1mm Wide Blade)


Sight is measured from the bottom to the top when OUT of the Slide.
Replacement Fiber is 1.5mm / 0.06”


Relief cut for front sight pin will need to be drilled.

Please Visit the FAQ for Installation Photos.

Please Make sure to Replace the Front Sight Pin, It holds the sight and the bushing in place.

Not for the 40P or any other transverse front sight cuts.

Additional Information

SKU 10085
Free Shipping N/A

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

  1. easy to install ! review by matthew wooten (creedmoor, NC) on 6/2/2015

    this is actually very easy to install compared to most front sights of other firearms. just follow the instruction on this website and youll be fine. btw it works great, huge improvement over the trijicons

  2. Big Improvement review by Kirk Johnson (Springfield, MO) on 6/2/2015

    This is a huge improvement in the site picture, especially outside. I kept my factory rear site on and replaced my front with this one and the glowing front site along with the white dots on the rear makes a clear picture. Five stars. Installation wasn't too bad, considering they recommend a gunsmith. I had to tool it down with a file to make it fit the gun, (about 30 minutes of work) but the rest of the job was pretty straight forward. Three stars. Would I recommend this to a friend? Absolutely!

Write Your Own Review

Only registered users can write reviews. Please, log in or register