CZ Hammer Pin Starter Punch

CZ Starter Pin Punch

CZ Bench Block

CZ Bench Block

#47 Front Sight Drill Bit

$2.00
.
Availability: In stock
SKU
30308

Using the Drill to Fit a NEW front sight.
Remove the roll pin using the appropriate 2.0mm Front sight Roll Pin Punch
Tap the old front sight out (towards the muzzle) using an appropriate soft hammer or soft block

Replace the new front sight into the dovetail and tap it toward the back of the gun until it seats in the rear of the dovetail cut. Make sure it goes all the way back.

Using the correct Number 47 Drill, for making the hole in the new front sight. Front Sight Drill

Drill through the roll pin hole (IMPORTANT) Drill from the left side of the gun to the right side, Drill cut clockwise and drilling from this direction will not cause the front sight to walk out as the drill starts to cut.

Replace the front sight pin, New Front Sight Pin


Please Visit the FAQ for Installation Photos.

More Information
US Only Yes
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account